Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

dynasty 350 no pre post after weld stops

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • dynasty 350 no pre post after weld stops

    i was out welding tonight and ran a few small welds then go to restart and no pre or post flow then wait 5 mins or so then it will start again but after u stop again it wont start what gives here ?

  • #2
    Originally posted by mikesystem View Post
    i was out welding tonight and ran a few small welds then go to restart and no pre or post flow then wait 5 mins or so then it will start again but after u stop again it wont start what gives here ?
    Any codes thrown up at all? Only time I have had that is when a power spike locked up the machine. I shut down, restarted and was fine. Also sometimes my finger controller is on when it should be off, and machine locks up.

    Only thing I can recommend is check your remote current/panel control.

    Did it ever straighten out?

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.