Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

best green horn jokes or story

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    The old stick flux down the shirt is a good one! My old foreman used to do this one to me... after welding on a fitting or Hard line to a hydraulic cylinder he would take out the oil can and out a drop and let it start to run before he called me over as he was testing it.

    We had a new guy who was more confident in his abilities than he should have been so almost anytime he ran out of wire/gas, the machinists and i would either turn off his gas, turn his voltage all the way down, turn off the feeder disconnect the remote leads/remote wire. Good kid for putting up with it so much, and he did level out but was sent packing for missing too many days

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.