Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

MIG gas regulator setting

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • MIG gas regulator setting

    Hello,

    What should the pressure be on a MIG regulator?

    Most regulators come "pre set" to something..
    but nobody says what it should be?

    I'm not talking about flow rate.
    Yes, I do understand the concept of choked flow.

    I can get the proper flow rate with either lower pressure (10 psi)
    or higher pressure (80 psi), but it seems like the higher the pressure,
    the more the first blast of gas when trigger is pulled.
    Is that good, or just wasting gas?

    thanks

  • #2
    Not sure I fully understand and bear in mind that I am not a pro, but I have two gauges on my mig, one for the pressure in the tank (which has no adjustment) and one for the flow rate. The flow rate is in cubic feet per hour and I usually set mine in the range of 18-20 cfh. This is with the trigger pulled.

    Comment


    • #3
      30 CFH. You should have a dual gauge reg on the tank one gauge shows bottle pressure and hrs other is your working pressure.

      Comment


      • #4
        Jim is not asking about the flow rate. There is flow and pressure. I have a high pressure and low flow fixed regulator to run my air lockers in my jeep. It does .5 cfm at 100psi. Jim wants to know what pressure, in psi, that a regulator flows at a given cfm. I'd have to look but I think my Radnor flow meter is at 50psi output. Not sure though.

        Comment


        • #5
          Thanks for your replies....

          Once again, I'm not talking about flow nor CFH.
          On a normal gas regulator, (ie. Acetylene) there are two gauges.
          One for tank pressure, other for line pressure.

          On a Mig regulator, there is tank pressure gauge and a flow meter.
          The line pressure gauge is missing.
          IF that line pressure gauge was there, what should the pressure be?

          I know that because of choked flow, the dynamic pressure
          will be lower when gas is flowing.

          So, if my regulator pressure (not the flow) is adjustable, what should that static/non flowing pressure be?

          thanks again.

          Comment


          • #6
            Most run 15 to 20

            Comment


            • #7
              Here is a link to a simple GMAW gas flow rate chart...

              Flow rates are in CFH... Cubic Feet Per Hour


              http://www.netwelding.com/MIG_Flow_Rate_Chart.pdf

              This should take the mystery out of it...

              ALSO

              Here is a video that may help to clarify things...

              http://www.youtube.com/watch?v=5bAJq_3XJOA

              Unfortunately some of this is sales pitch... but the basics are there and easily understandable..
              Last edited by H80N; 09-27-2013, 06:18 AM.

              Comment


              • #8
                Jim, why would you need this information? Just curious.

                Comment

                Working...
                X
                Special Offers: See the latest Miller deals and promotions.