Announcement

Collapse
No announcement yet.

Older 5 pin tig pulse control

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Older 5 pin tig pulse control

    Have a dialarc HF and the other day I went to go buy a Mic 4 interface control so I could use some 5 pin foot control and finger controls that I have and the guy had pulse control sitting there. Looks much like the PC 300 that I've seen before but older looking and with the 5 pin in and out. It was an estate sale and the guy didn't know much about it I took a chance and grabed it. I'm not sure if its just not meant for the old dialarc or if its not working. Mic 4 is working fine. With pulse hooked up to mic4 and on welder it act the same with no change. Checked the basics on/off switch and power going to and out of transformer seems ok. Any ideas??Name:  2bfe25d18eccfa6e73a191f7cacc34b6.jpg
Views: 1
Size:  59.4 KB
    Last edited by kevdidy; 09-20-2013, 01:25 PM. Reason: Move picture
Working...
X