Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

cry or does not matter

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • cry or does not matter

    I have a SPECTRUM 375. It has always been hard to adjust the air pressure.

    Today the torch would not fire. The pressure was (I thought) right at 60psi.

    I could not get knob to move....even with channel locks!

    I took the cover off.....figured I take apart the regulator much damage could I do. I'm a tech.....and it ain't working now.

    So I get the plastic nut holding the regulator on removed. I push the adjust knob through the face. I tilt the regulator up. It's then that I notice the inscription on the face of the knob.


    I am retired now, but when I was working I would have expected my compadres to be laughing at me, not with me!

  • #2
    cry or does not matter

    Haha! Sadly your not alone. I've done that a few times


    Special Offers: See the latest Miller deals and promotions.