Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Spectrum 375 x-treme power light blinking

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Spectrum 375 x-treme power light blinking

    Earlier in the year, I bought my spectrum 375 x-treme plasma cutter. I used it twice. Today, It will not operate. Machine turns on, when I pull the trigger the power light starts to blink.
    Things I've checked and verified:
    Voltage is 240v also tried on the 110v plug
    pressure is within range and have adjusted it from 90-130 psi.
    tips, etc are brand new miller
    moisture trap inside machine is fine

    I have looked all of the older posts on this machine with similar problems and have come up with nothing. Any help would be greatly appreciated!

  • #2
    Double check that you have 240 volts getting to the unit.
    Check trouble shooting grid in your owners manual.
    If under warranty take to warranty shop for repair.


    • #3
      There are 3 of the x-treme 375 units, maybe serial# would be handy....


      Special Offers: See the latest Miller deals and promotions.