Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

XMT 300 CC CV Diagnosis Unusual Sounds and LED Dysfunctional Miller Video Link

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • XMT 300 CC CV Diagnosis Unusual Sounds and LED Dysfunctional Miller Video Link

    Newly acquired welder that welds as expected both with stick and wire feeder.

    When powering up there is a one time loud click. also, when the output contactor is moved into the ON position there a constant buzzing noise.

    When purchased the input was wired for 3 phase. I converted it to single phase and bypassed the red wire.

    Serial Number KD395855

    Video Link:

    http://www.youtube.com/watch?v=JjHQD...ature=youtu.be
    Last edited by jimybud; 09-10-2013, 09:01 AM.

  • #2
    Buzzing is completely normal, the loud click is the unit determining the supplyed power, and if it actually works you have no worries....

    Comment


    • #3
      XMT 300 CC CV to Spoolmatic 3 Cable Connector

      could someone provide a part number or a link to where I could purchase an Cable connector? I have attached a photograph of the two units I want to quick connect.Name:  44a24a3620c1518c046663f9540f4501.jpg
Views: 2
Size:  41.6 KB

      Comment


      • #4
        sorry I could not figure out how to bring the photograph inline so it will have to be clicked with the mouse to view it. the link is below.



        Name:  44a24a3620c1518c046663f9540f4501.jpg
Views: 2
Size:  41.6 KB

        Comment


        • #5
          Originally posted by jimybud View Post
          sorry I could not figure out how to bring the photograph inline so it will have to be clicked with the mouse to view it. the link is below.



          Name:  44a24a3620c1518c046663f9540f4501.jpg
Views: 2
Size:  41.6 KB
          Try this

          http://miller4less.com/product_info....ducts_id=36406

          Manual page #28 item #17

          http://www.millerwelds.com/om/o2205l_mil.pdf

          Comment


          • #6
            Looks to me that he has the female Dinse, but needs the male plug to go into it. But I've been wrong way more times than I can count.

            Comment


            • #7
              Originally posted by pin2hot View Post
              Looks to me that he has the female Dinse, but needs the male plug to go into it. But I've been wrong way more times than I can count.
              OK then... was not sure about that...

              http://weldingdirect.com/connectors.html

              Comment

              Working...
              X
              Special Offers: See the latest Miller deals and promotions.