Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Roughneck 1e with no throttle switch

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Roughneck 1e with no throttle switch

    Been looking on here and in my owners manual I downloaded but can't find a pic of the throttle switch just 3 wires one hooked to a plug at back where pull rope cover is other 2 hooked together. Motor is a Koehler. Any help would be appreciated.

  • #2
    Was told the switch should be labeled weld / power and control the idle speed from low to high idle.

    Comment


    • #3
      Look at the parts part of the manual. It just a toogle switch look #28 the face were the controls are and #97 the toogle switch.
      Attached Files

      Comment


      • #4
        Another pic out of the manual
        Attached Files

        Comment


        • #5
          I am referring to page 14 , mentioned in 6-2 "throttle control." Sorry I said switch, what can I say I'm a teacher, don't always read real well!

          Comment


          • #6
            I was suprised it didn't show anything on that page.

            Comment


            • #7
              Just mentions it, but no picture, hoping somebody will snap a pic of theirs on their roughneck, I guess I can adjust throttle manually till I figure it out.

              Comment

              Working...
              X
              Special Offers: See the latest Miller deals and promotions.