Announcement

Collapse
No announcement yet.

New to forum and have a ?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • New to forum and have a ?

    My first post and I have a question about my mig. My XR wire feeder with a Python Aluma-pro gun will work normally until I release the trigger. The gas will keep flowing until I hit the jog/purge switch. Is it the gun or the feeder?
    Thanks, Randy

  • #2
    some have a bult in post flow setting,a serial # would be handy

    Comment


    • #3
      Originally posted by Clyde View Post
      My first post and I have a question about my mig. My XR wire feeder with a Python Aluma-pro gun will work normally until I release the trigger. The gas will keep flowing until I hit the jog/purge switch. Is it the gun or the feeder?
      Thanks, Randy
      Serial # lg141314w

      Comment


      • #4
        OK, remove the right side cover, inside you'll see a control board and a red 2 pin dip switch, The first one is for a 0.5 second preflow, the second one is for a 3.5 second post flow. If you don't want any post flow merely turn that switch down to off. There is no time adjustment, either you want it or you don't.

        Comment


        • #5
          My bad, machine has been working properly for a couple of years now, just recently started this problem. No switches have been moved. Was told it might be trigger switch,bought one from local distributor and was wrong one. I have all the manuals but they have been no help so far. Thanks Randy

          Comment

          Working...
          X