Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

miller 22p12 problems

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • miller 22p12 problems

    Hi, I've suddenly got a problem with my wire feeder.
    It's dead...or if I press JOG switch it starts to feed.
    But nothing hasppens if I press the pistol trigger.
    I have connected it up to 2 different Miller xmt 350, even got 2 22p12 wire feeders, and none of them are working.
    It's been sitting in my garage for half a year, but both worked when I placed them there.
    Is there something I could easily check/measure?

    Regards
    Panasync

  • #2
    Found the problem, bad connection on the printcard inside wire feeder.
    So now it's working fine

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.