If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have used the ac on my TB exactly 3 times. All 3 times were on a batch of drill stem that was going in a fence. It was magnetized and played heck with the 6010 I was using.
So long as the machine has good ac aux power then you can use another machine powered from it if needed. Still, if it was available, I would pay more to have it.
I never welded on AC until I got a Dynasty and experimented with it on thin tubing and plate (3/16" or less). Not sure why, but it's less likely to burn holes using 3/32 6011 than on DC- in my hands. Since the Bobcat, I've found additional uses in restricted access corners and magnetized fence pipe recalcitrant to the ground cable winding trick. As a matter of fact, I regularly use all three polarities depending on the material thickness and weld type, mostly farm & ranch applications.
I purchased a Bobcat because it had AC weld polarity.
I agree with most people here, i really use the trailblazer 302 AC output doing portable TIG welding with the HF-251 D , and it works awesome. I have welded lots with the inverters , but for the variety of work i do i like this setup. and for heavier work a guy can go DC and use the spoolgun. Stick welding with the AC is a very handy card to have up ones sleeve , it my not be used all the time but it can save a guys azz once and a while. I guess if the unit i got every pooches out i'll have to buy an inverter and run it off the generator. i sure wish they retained the AC capabilities , but i suppose they build what the majority of people want and use.
I have a welding addiction
...the only stupid question is the one you didn't ask