If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am using a Bobcat 225 [not mine] with a Onan engine. We were welding and everything was going great, shut it off for a few minutes and went to start and no go. There was no spark at all. Checked oil level and it was down to mark so we filled to line. Still no spark. I know there is a low oil cut out is there a reset somewhere? Any other ideas appreciated.