Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

bobcat 225 dying issue

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • bobcat 225 dying issue

    I've got a 2010 bobcat 225 with the Robin/Subaru motor that I acquired with 70 hours on it a little while back. I've had it in my truck about a month. When I crank it the first time in the morning it runs good about 45 seconds then bogs down and dies blowing dark smoke. Its always about 15 -25 seconds after it idles down from start up. Then when I restart it acts flooded then goes ahead and starts and is fine all day. Sometimes it does it after lunch if I take a very long one. I'd appreciate any advice or help. It ain't keeping me from work but it is something I worry about. Thanks a lot!
    Last edited by fencemaker; 07-26-2013, 04:59 PM.

  • #2
    A serial# would be handy, is it a front or rear engine unit?

    Comment


    • #3
      Rear motored if rear is where the motor is opposite the control panel. I'll get the serial # to ya soon as I can, I'm outa pocket. Thanks a bunch!

      Comment


      • #4
        The serial # is LK21519H

        Comment


        • #5
          It's just a guess at this point without more information, but it sounds to me like the carburetor float needle valve is not closing completely and the fuel pump is over filling the float bowl, which then causes the motor to run rich and stall. This would produce the "flooded" condition on restart too. I would replace both the float needle valve and the float, since older floats frequently either leak or absorb fuel and no longer float at the correct level.

          Charley

          Comment


          • #6
            Originally posted by CharleyL:310260
            It's just a guess at this point without more information, but it sounds to me like the carburetor float needle valve is not closing completely and the fuel pump is over filling the float bowl, which then causes the motor to run rich and stall. This would produce the "flooded" condition on restart too. I would replace both the float needle valve and the float, since older floats frequently either leak or absorb fuel and no longer float at the correct level.

            Charley
            Yes that was my first thought but it does it at the same time every cold start methodically. If it were a bad needle and seet or float wouldn't it do it all the time?

            Comment


            • #7
              Originally posted by fencemaker View Post
              Yes that was my first thought but it does it at the same time every cold start methodically. If it were a bad needle and seet or float wouldn't it do it all the time?
              Sounds like the choke is staying on too long.

              Comment

              Working...
              X
              Special Offers: See the latest Miller deals and promotions.