If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
When you turn "off" the remote , you are turning "on" the welder output.
The buzzing you hear should be the HF points arcing.
These older units do not switch off the HF when in panel control. (remote off)
Place HF control switch to off when stick welding. Buzzing should stop.
New welders say out put on or off for the same switch. you have to think backwards.