Announcement

Collapse
No announcement yet.

spoolmatic 30a

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Originally posted by kbenz View Post
    yes, I have checked all that I can. Nothing in the trouble shooting refers to the problem I am having, That is why I am having the outlets checked before I go any further
    Not True

    Check Section 9-2. Auxiliary Power Troubleshooting Page 33 of the manual

    http://www.millerwelds.com/om/o405e_mil.pdf

    .

    *******************************************
    The more you know, The better you know, How little you know

    “The bitterness of poor quality remains long after the sweetness of low price is forgotten”

    Buy the best tools you can afford.. Learn to use them to the best of your ability.. and take care of them...

    My Blue Stuff:
    Dynasty 350DX Tigrunner
    Dynasty 200DX
    Millermatic 350P w/25ft Alumapro & 30A
    Millermatic 200

    TONS of Non-Blue Equip, plus CNC Mill, Lathes & a Plasmacam w/ PowerMax-1000

    Comment


    • #17
      That's why I have Jeff coming out to check my outputs. until then I do not know if my problem is the outputs or not. It may have just been a wire rubbed raw and shorted out (I hope)

      thanks

      Comment


      • #18
        got back to it again. outlets checked out fine. Replaced the 120v power cord that fried with a 14g cord to the wc-115a. ran some wire. all seemed ok. thanks for the input

        Comment

        Working...
        X