Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Strength of equipment

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Strength of equipment

    How does this rack stay strong enough to hold up to 500kg loads with all the holes? I would have thought it would weaken a structure.

  • #2
    Add Content
    Attached Files

    Comment


    • #3
      I don't think 500kg is that much for that structure depending of course on the guage of the tubing and how far you drop the 500kg load onto it. That said each tube is essentially 4 angles with the extreme edge of their legs re-inforced by the interconnection to to the adjacent angles. If you partially collapse any of the tubes then it is a whole other ball game. Take a look at adjustable pallet racking. It holds 1000s of kgs and is also punched full of slots.---Meltedmetal

      Comment


      • #4
        The vast majority of the load is compression, so I'd say that is how it does it. If, for example, one end of the rack was securely attached to the wall, with it cantilevered out (no support bracing) and the weight placed out near the end away from the wall, the weight bearing capacity would be hugely less than when the load is compression as it is in the picture. Kind of like how you can sit on the end of a pretty skinny rod with a seat on the end of it as long as it is pointed straight up, but if you put one end of the same rod in the vise and push down on the other end, you can easily bend it.

        A lot of what can be supported by any structure depends upon the material, but the direction of the forces involved and if the loads are compression, torque, bending, or whatever is also VERY important in how the structure is designed and what sort of loads it can bear.

        Comment


        • #5
          Strength of equipment

          Unreal information. Thanks again, I was having doubts about building something similar. But I'll bang it out now.

          Comment


          • #6
            Here is an example we have all seen.and perhaps used ourselves.

            As Don pointed out, the loads are mostly vertical in both cases.

            However all it takes is a bit of side load or a weak side member and the frame could collapse.

            4 empty soda cans will support a person's weight if they are undamaged but if there is a dent in one, look out.
            Attached Files

            Comment

            Working...
            X
            Special Offers: See the latest Miller deals and promotions.