If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Tested leads on another machine and they work fine.
When I try to stick weld the amp meter reads about 6 to 7 amps at about 30 volts. when I stick the rod the volts drop to 1 or 2 volts and the amps go to about 35...
I had this problem a while back, and due to the cost, it wasn't worth repairing. So if the machine is still under warranty take it in. otherwise, I believe you've lost your pc1 board and boost board. Big bucks