Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

350 LX High freq cuts out

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 350 LX High freq cuts out

    Hey gang. Have a 350LX and the high frequency cuts out after about 20 minutes of use. I pulled the side panel to observe the points and the arc is strong and constant then it just cuts off and if you touch the chassis you get a shock.

    Anyone have experience with this?

  • #2
    Look close at the wiring. I found a wire that had layed on top of a screw and had shorted to the chassis. I just repaired the wire and all was good.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.