Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

14 pin receptacle 250 Syncro

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 14 pin receptacle 250 Syncro

    Serial # KC320772

    Connection K is supposed to be ground. It is on the other machines (KG234929 etc).

    My concern is that K has no metal pin receptacle- therefore no ground.

    Diagram (o353h_mil KC 320772 page 31) shows:

    Pins A,B.C and E grounded.

    Pin D goes somewhere- is it grounded?

    Pin K is not connected.

    My 14 pin remote will be returned this week.

    Do I ignore the missing K on this machine, plug it & go?

    Thanks, the archives have been very helpful but find anything, anywhere for this issue.

    Mike

  • #2
    Pins A, B, C, D & E are not grounded. Those are capacitors (C-16 thru 19) connected to them and ground.

    No, your machine doesn't use the K pin (chassis ground) nor the G pin (circuit common/neutral) that when used are typically common to each other so ignore them and when you get your remote back, plug it in and get welding.

    Comment


    • #3
      Thanks for your reply

      The detail-

      And the definitive 'ignore/get welding'

      Mike

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.