Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

2050 torch.

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • 2050 torch.

    I must have a 55 ?? I dont know anything about plasmas but doubt the welding supply has all the parts ojn hand.m This was less than ideal, so was the one from my old linc. On this the protector and some kind of washer fell off, will have to get a pic today but what are options to improve/change it? Different head, same lead etc?

  • #2
    I never fully understood the gouge fittings, at Miller I asked and theyh didnt have the stuff there at the time.

    But its like all these mig guns, models, dont know one from another. I just use what comes on the machine.


    • #3
      "Some kind of washer" sounds like a swirl ring. If it is a Miller, they ought to have a parts list available.


      Special Offers: See the latest Miller deals and promotions.