Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Maxstar 150 STL "gas impedance" resolved

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Maxstar 150 STL "gas impedance" resolved

    Funny thing...the reason the gas wouldn't flow was because of dirt. Never would have guessed. The dirt was in the outlet too far back to see by eye. However, with the flow wide open I gently pushed a piece of filler rod into the gas port. Chunks of dirt blew out and thus resolved my issue! I didn't have the leads attached as I switch between TIG and SMAW frequently.
Working...
X
Special Offers: See the latest Miller deals and promotions.