Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Millermatic 250 not working

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Millermatic 250 not working

    millermatic 250 the problem i'm not getting voltage to wire drive motor. there is a red lite on circuit board that comes on when trigger is pressed but goes right out. there does not seem to be voltage at the positive and negative lead lugs. should these be energized when trigger is pressed. Wondering if anyone has had this problem.
    Last edited by sircharles; 05-14-2013, 11:14 PM. Reason: error
Working...
X
Special Offers: See the latest Miller deals and promotions.