Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Air compressors

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Air compressors

    Those of you that have air compressors on your big do you power etc....thanks

  • #2
    It would help if we new what your needs are such as Air arc, Jack hammer, Plazma, impacts, sand blasting, Etc.

    I run the Ingersorand 30 gallon tank with a 13HP Honda, I operate everything mentioned above except a Jack hammer and operating a sandblaster is limited so I hook into the compressor on my other truck and use both compressors and I have steady air.


    • #3
      Air compressors

      Thanks PW....planning on running plasma and air tools....impacts...die grinders etc...thanks


      • #4
        What ever compressor you look at, check the cfm. You want to make sure the advertised cfm is at 90psi or higher. Some company's say its 15 cfm but that's at zero psi and only like 8 cfm at 90psi.


        • #5
          Air compressors

          Most plasma uses round 4-6 scfm@90 psi and your air tools( besides a sander) use round 3-4. You also need to think if you need portability or just in your garage. Gas powered comps are a bit more than elec power ones( a lot more really). CampbellHaus has a 60gal/230v at 10.2 @90 for $470ish and IR has a 8gal/gas at 11.8@90 for$999. This is at my Tractor Supply.


          Special Offers: See the latest Miller deals and promotions.