Announcement

Collapse
No announcement yet.

Wc-24

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Wc-24

    The WC-24 controller the understanding I have of it is you slug it into the 14 pin connector and then it, takes the wires from it and uses the ones required to have a 10 pin? I was curious if I was to spend some time with a tester is I could get a 14 pin plug and also a 10 pin and make my own adapter or is it much more invoked than that? Thanks Jeff

  • #2
    It changes the voltage from 24v at the machine to 30 volts at the gun. I think?

    See below for a better explanation.
    Last edited by MMW; 05-08-2013, 09:34 AM.
    MM250
    Trailblazer 250g
    22a feeder
    Lincoln ac/dc 225
    Victor O/A
    MM200 black face
    Whitney 30 ton hydraulic punch
    Lown 1/8x 36" power roller
    Arco roto-phase model M
    Vectrax 7x12 band saw
    Miller spectrum 875
    30a spoolgun w/wc-24
    Syncrowave 250
    RCCS-14

    Comment


    • #3
      It takes the 24Vac from your machine, tosses it into a DC DRIVE controller, the 30A sends a potentiometer signal to it, and it sends out the 0-36dc volts to run the guns motor.

      Now if you can do that merely by switching a couple wires, giver.

      Comment


      • #4
        Wc-24

        Ok thanks for the explanation, I thought it may be something simple but not quite! Thanks ill have to get a controller I was just trying to save a few bucks

        Comment

        Working...
        X