Announcement

Collapse
No announcement yet.

Millermatic 350/350P and Weld Procedure Specification

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Millermatic 350/350P and Weld Procedure Specification

    Using a Millermatic 350/P... I've got to follow the parameters of an approved weld procedure specification pretty close, namely Amps, Volts and Wire Feed Speed.

    I can see how to adjust Volts and Wire Feed Speed, however how can I adjust the amperage, and how do I see the machine is actually operating within the amperage range I need to stay within according to the WPS?

    Other welding machines I've used in the past had dials and gauges for both Amps and Volts.

    Thanks!

  • #2
    6-4. Weld Status
    When trigger is released on a MIG gun, spool gun, or push-pull gun, the last actual amperage and voltage will be shown on the displays for 5 seconds. The VOLTS and AMPS indicator lights will illuminate under the displays and each value will appear in the corresponding display.
    If a programmed value requires adjustment after the arc is extinguished and during the 5 seconds display of actual values, turning either knob will cause actual values in the displays to be replaced by programmed values for adjustment purposes.

    http://www.millerwelds.com/om/o1327ah_mil.pdf
    Ed Conley
    http://www.screamingbroccoli.net/
    MM252
    MM211
    Passport Plus w/Spool Gun
    TA185
    Miller 125c Plasma 120v
    O/A set
    SO 2020 Bender
    You can call me Bacchus

    Comment

    Working...
    X