Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

DVI2 Help

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • DVI2 Help

    Picked up a DVI2 welder, using gasless wire and not for sure how to change polairty for gasless, picture attached of how its wired now.Name:  01b2369bb1fed5ca5f4d7025dd7c7fc3.jpg
Views: 1
Size:  56.0 KB

  • #2
    The short wire should stay on that stud and the long wire should be on the red stud. If you switch to gas you'll need to change them. Where it is now you won't be able to weld.

    Comment


    • #3
      Originally posted by elvis View Post
      The short wire should stay on that stud and the long wire should be on the red stud. If you switch to gas you'll need to change them. Where it is now you won't be able to weld.
      Thanks much, i will change it tonight and give it a try.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.