Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

I needed a sod cutter so I brought out the plasma and the MM180

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • I needed a sod cutter so I brought out the plasma and the MM180

    If you should need to make a handle a 1" EMT conduit is a perfect drive on fit over a 3/4" BP nipple.

    I beveled the 3/4" nipple's edge, laid the blade down on the welding table with the 3/4" angle iron flange looking down and could only drive the 1" EMT on the nipple about two inches with my 8 lb sledge. It didn't need to be welded or bolted on the handle fits so tight. I think what stopped it from going on farther is the shaved galvo on the inside caking up.



    Last edited by tackit; 04-21-2013, 03:43 PM.

  • #2
    Looks real nice. Always nice to save money and having made something you can use........Fireman Bill

    Comment


    • #3
      Thanks Fireman Bill, it's simple but a good project for guys just starting to weld.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.