Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

millermatic 35 no wire feed

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • millermatic 35 no wire feed

    I have a millermatic 35 it stopped feeding today after doing several welds. It appears that the drive motor has stopped working. Just wonder if anyone has had this problem and what to look for. thank you
    Last edited by sircharles; 04-20-2013, 08:54 PM.

  • #2
    wire feed problem

    Its could be the motor is bad or your trigger wire is shorted or you could have the drive rolls too tight I work a at repair shop and alot of times on those little millermatic the fan motor goes bad under warranty?


    • #3
      Never mind about the fan motor I was thinking of those little 110/230 millermatic sorry


      • #4
        millermatic 35 no wire feed

        Could be the liner. Mine done that before and the liner was stopped up


        Special Offers: See the latest Miller deals and promotions.