Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Adapting spool matic 1 to esab

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Adapting spool matic 1 to esab

    Need help hook ing spoolmatic1 to esab multimaster 260?
    Few years ago I asked this question and got some good answers but never followed thru
    I don't have the esab module in it yet but am running it off of a trailblazer with a wc1 now

    Any help is appreciated thanks

  • #2
    48 views and no replies this must be a difficult to do


    • #3
      Might just be that there are not many people familiar with that combination. Did you ask that question and get answers on this forum in the past? If so you should be able to search the forum to find the original posts.-Meltedmetal


      • #4
        That was easy enough to find...Bob


        Special Offers: See the latest Miller deals and promotions.