Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Nice project for someone with a plasma table

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Nice project for someone with a plasma table

    With drawing software, a tempered cardboard cut out to follow and a plasma outfit one could make one piece sides and weld angle iron on the bottom for the feet. The collars to make the adjustable dies I think I've seen in shafting catalogs.









Working...
X
Special Offers: See the latest Miller deals and promotions.