Announcement

Collapse
No announcement yet.

Help- Ranger 8 Died !

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Help- Ranger 8 Died !

    Cruizer, Help !

    I was out on a job this morning, when the engine just died. ( Fuel Tank Full )
    I Took the gas line off the electronic fuel pump, & no gas was comming out when it was cranked.

    So, can I take it off & clean it, or is it a sealed unit ?
    If it's shot where can I get another one ?

    Ranger 8- Serial#- 10110 U1940808484

    .........Norm
    sigpic
    Sunrise Outside My Shop In Delhi, Ontario

    - Arcair- K 4000 CAC.

    - LN-25 Wire Feeder

    - Lincoln Ranger 8- Engine Drive- CC\CV:



    - Lincoln Power Mig 180C
    - Spoolgun.
    - DeWalt Chop Saw .
    - DeWalt Compressor - 13cfm, @ 100 psi.

    www.normsmobilewelding.blogspot.com

  • #2
    Onan, or Honda? doesn't matter much as neither had a electric fuel pump in that era. Now if it does, the power for it would have been routed through the oil pressure switch. So either the pump has crapped out, little oil in the engine, thus no oil pressure, or the wiring to the pump has come off.

    Comment


    • #3
      Cruizer, It's a Kohler CH18S engine, 625 cc. - spec. 62514, ser.# 2422116047.
      It says electronic fiel pump on the side of it.
      Oil & filter change last week.

      I don't see any loose wiring.

      ...........Norm
      sigpic
      Sunrise Outside My Shop In Delhi, Ontario

      - Arcair- K 4000 CAC.

      - LN-25 Wire Feeder

      - Lincoln Ranger 8- Engine Drive- CC\CV:



      - Lincoln Power Mig 180C
      - Spoolgun.
      - DeWalt Chop Saw .
      - DeWalt Compressor - 13cfm, @ 100 psi.

      www.normsmobilewelding.blogspot.com

      Comment


      • #4
        One of my old welders had that engine, I don't remember which welder but it had the same problem. I took the fuel pump off and apart then gently cleaned it with carb cleaner then put it back on and it worked fine.

        Comment


        • #5
          Back to work !!!!!!!!

          Weldon, Thanks. It's a sealed unit, No chance to take it apart as far as I can see.

          I went to NAPA. auto parts, just to check if by chance I could get a universal electronic fuel pump, I lucked out, they had one. $82.50 after tax.

          I installed it, & it fired right up first try !!!!!!!
          Now I can go back & finish the job I started today !

          Back on the road again .

          ........Norm
          sigpic
          Sunrise Outside My Shop In Delhi, Ontario

          - Arcair- K 4000 CAC.

          - LN-25 Wire Feeder

          - Lincoln Ranger 8- Engine Drive- CC\CV:



          - Lincoln Power Mig 180C
          - Spoolgun.
          - DeWalt Chop Saw .
          - DeWalt Compressor - 13cfm, @ 100 psi.

          www.normsmobilewelding.blogspot.com

          Comment


          • #6
            OK, if that pump runs to the right side kohler cylinder head, then just take it out of the circuit Plumb around it, cut the wires to it. It's only there for priming the one in the head, and thats for real high altitudes.

            Comment


            • #7
              Cruizer, See post above !
              I'm Not plumbing anything, It's been fixed- New fuel pump !

              ..........Norm
              sigpic
              Sunrise Outside My Shop In Delhi, Ontario

              - Arcair- K 4000 CAC.

              - LN-25 Wire Feeder

              - Lincoln Ranger 8- Engine Drive- CC\CV:



              - Lincoln Power Mig 180C
              - Spoolgun.
              - DeWalt Chop Saw .
              - DeWalt Compressor - 13cfm, @ 100 psi.

              www.normsmobilewelding.blogspot.com

              Comment

              Working...
              X