Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Dinse to tweco adapters

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dinse to tweco adapters

    First off why does miller make the xmt 350 with two different size female dinse connectors? I believe 1/2 and 3/8 are the two sizes. I would like to change these out to a tweco style twistlock, don't care to use the dinse to tweco adapters anymore. I beleive they are made but cannot find them. Anyone know if these exist and where to purchase? I found a part number some one gave a few years ago on the Hobart board but cannot find any info #209 219

  • #2
    leave the # sign off the part number in search box

    Here's their parts list
    Last edited by tackit; 04-12-2013, 06:45 AM.


    • #3
      They sell lots of connectors and adapters here:

      And Cyberweld has this:

      Would be cheaper to buy a dinse connnector and tweco female and join them with a cable than that connector at cyberweld.


      • #4
        Yep, leaving out the # and spacing pulls up more info, " Tweco 209219 ". Still can't find a picture to make sure if it is the correct item yet.
        I bought another 350 and am do not care to keep adding more connectors/adapters,cost is not an issue.


        Special Offers: See the latest Miller deals and promotions.