If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thanks for asking this question. I also have a TB 302 and have often wondered what would be involved to hooking up a spool gun. I have an older Miller 185 spool gun, and most likely it will be too outdated to use with a TB............I will be watching this post for more information............thanks.
I expect that with the 185 spool gun you would need the SGA100C. I have a 185 that works with a SGA100C. I see that the 3035 is also used with the SGA100 so I suspect they are the same as the 185. That may also include the 3045 which I think is a 3035 with a heavier barrel(= higher duty cycle?). Compare the parts list and manuals of all three to verify. For the original poster yes, one would need to match the spool gun adapter to the spool gun, which is ......? -----Meltedmetal
Maybe a few pics of your spool gun would help someone identify it. I can't find much online about Canox equipment or that model. Is it 30 amp or is it a miller 30A painted red? 30 foot lead?--Meltedmetal
Can't seem to get any pictures to add for me but I'm positive it's just a miller 30A with roughly a 25-30' lead I'm also ruinous with the adapter for the TB would that also work on a CST250?? I'm thinking about purchasing one for the tig side thanks if pictures are needed email me a firstname.lastname@example.org and ill send pics that way thanks