Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Miller 625 Plasma Questions

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Miller 625 Plasma Questions

    Can anyone tell me why this 625 comes with 30A and 40 tips/hardware?

    I'm running on 220V mainly, curious why I would ever swap in the 30A hardware?


    Is the 30A hardware just for running on 110V?


    Will the 40A stuff cut as nice when turned to low power? will the 40A tips even work on 110V?

  • #2
    The 30 amp tips will cut a smaller kerf when using 30 amps or less. You have to use the 40 if you are using over 30 amps. You can use the 40 under 30 amps but will cut with a larger kerf.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.