Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Need advice and info on syncrowave 350/ and 351

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Need advice and info on syncrowave 350/ and 351

    I would like to know what changes were made on the Syncrowave 350 and 351 over the years from early 90's up till most present.... What was the difference in the two in general?? I am in the market to purchase a nice used syncro for a commercial machine shop setting.. I am confused as I have seen differences in panel controls..







    I will post photos of what I have found so far as I hope to clarify what my concerns are..

    Name:  aa6f9331b117f1e87b69c8616711098f.jpg
Views: 1
Size:  21.0 KB Name:  8adf503714be09a920074bde32af5a60.jpg
Views: 1
Size:  38.0 KB


    The image on the left is a 1996 350... The right is 351 1995... Obvious less controls on the right.

    I have seen variations of the two as well with different control panels..

    If anyone has leads to a good working condition 350, I would appreciate it as well.

    Thank you,
    TheTester
Working...
X
Special Offers: See the latest Miller deals and promotions.