If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a MM211 and I change between the spool gun and the standard gun. It's a tight fit going into the welder. I noticed today one of the o-rings was torn. Is there any recommendations for lube on these o-rings?
Loctite brand Silicone Lubricant (their part number is 51360) may be just what you need...that number is for a 5.3 ounce tube and is something I keep in my toolbox for use on rubber stuff that needs some kind of slickum on it.