Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

MM211 o-rings

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • MM211 o-rings

    I have a MM211 and I change between the spool gun and the standard gun. It's a tight fit going into the welder. I noticed today one of the o-rings was torn. Is there any recommendations for lube on these o-rings?

  • #2
    I have used the Syncolon on O-Rings.

    http://www.amazon.com/Synthetic-Grea.../dp/B000XBH9HI

    http://www.amazon.com/O-Ring-Silicon.../dp/B002KTJF2S

    Comment


    • #3
      Loctite brand Silicone Lubricant (their part number is 51360) may be just what you need...that number is for a 5.3 ounce tube and is something I keep in my toolbox for use on rubber stuff that needs some kind of slickum on it.

      Comment


      • #4
        Use a very thin coat of high-quality silicone grease like NAPA Sil-Glyde, Ford Caliper/Dielectric, or Ford Electrical.

        .

        I also use it on my bottle fittings to help prevent tiny leaks & prevent corrosion/seizing.

        Comment


        • #5
          MM211 o-rings

          Great input, thanks guys.

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.