Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Bluestar 2E Run/Idle issue

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Bluestar 2E Run/Idle issue

    I have a Bluestar 2E that will not automatically rev out of idle when striking an arc in Run/Idle mode. I have to set the toggle to Run manually to weld. I would like to repair the problem but do not know which part controls this function. Any advice would be greatly appreciated.
Special Offers: See the latest Miller deals and promotions.