Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Fleck in my welds

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Fleck in my welds

    You all you goods guys out there.
    Starters: Dynasty 200 DX, 2006 year. Doing 3/16" Al. Using 3/16" x 1 1/2" angle mill finish. 1 /1/4" pipe butt weld. Running 185 amps, 70 bal 120 frq. all good. I'm guessing 6000 series. Problem was went to Anodized pipe kicked to 200 amps , 70, 130. full of pepper flacks. I tried gas at 20 to 35 cfh or what ever. Welds look fine just dirty. 3/32" 1.5 Lanthaitd tried orange and red.

    Any Help Out There??

  • #2
    Those are chunks of anodized finish on the top of your beads. You need to completely clean the area of the weld to eliminated those.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.