Announcement

Collapse
No announcement yet.

Weld Cable Connector Question

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Weld Cable Connector Question

    I have an old set of 2/0 weld cables and they both have an inline connector that I have never seen before, hoping someone can identify? Problem is that they have no name on them. Each side has four "fingers" that i assume are supposed to grab and engage with the fingers on the mating connector. The fingers are about 2" long and there is a rubber boot that covers the fingers that slightly accordions in when it touches the opposing boot when the connectors are pushed together.

    I assume that these are now obsolete, but wondering if they are OK to use. Any ideas?

  • #2
    Try it out and see. A picture might help also.

    Comment


    • #3
      I would just put Tweco connectors on. Model MPC-2 will fit 2/0 cable.

      http://www.buyweld.com/2-mpc.html
      MM250
      Trailblazer 250g
      22a feeder
      Lincoln ac/dc 225
      Victor O/A
      MM200 black face
      Whitney 30 ton hydraulic punch
      Lown 1/8x 36" power roller
      Arco roto-phase model M
      Vectrax 7x12 band saw
      Miller spectrum 875
      30a spoolgun w/wc-24
      Syncrowave 250
      RCCS-14

      Comment

      Working...
      X