Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

dynasty 200dx PLUGS

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • dynasty 200dx PLUGS

    Im very noob when it comes to electricity!
    Here ,i have a L630-p screw back on my welder(green in green, white in "x" and black in "x") so far so good???
    I have cut back the red one!the L630-p is a 30A,250v is that good enough?
    On my pigtail i was planning on having a female(L630-c hook exactly like my welder is except the black) and at other end will be a male 15A110v
    Also another pigtail made as an extension cord hooked up with (L630-p and L630-c)
    Am i ok???? Its been a little pain as even electrician dont understand...
    Let me know if anything here is wrong or ok thanks

  • #2
    dynasty 200dx PLUGS

    Revised :
    Im very noob when it comes to electricity!
    Here ,i have a L630-p screw back on my welder(green in green, white in "y" sorry and black in "x") so far so good???

    Comment


    • #3
      That's sounds good

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.