Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

question on hf box

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • question on hf box

    I just got a miller hf-251d-1, I am running it off my aead... it welds nicely. I am used to tagging aluminum without foot pedal or finger control but it would be nice. I see the of box has a 14 pin receptacle. Is it able to control the amps if I just connect the pedal to the of box? Or does it also have to run to the welding source?

  • #2
    Must be connected to the welding source for amp control.

    Comment


    • #3
      Aead

      In general, you simply connect the foot control to the HF and you are in business.That is the beauty of the Miller 14 pin system. On the other hand if your AEAD is old enough that the 14 pin receptacle is not there, you are out of luck as none of the normal Miller foot controls is compatible with the older AEAD's and it in addition would require wiring into the machine. weldersales

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.