Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

No wire feed on Miller Matic 35S

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • No wire feed on Miller Matic 35S

    New to the forum...I have an old MillerMatic 35S that will not feed the wire. Cr1 is not fully engaging, I have checked all the full wave bridge retifiers and all appear to be OK.. I might have a bad CR52.. but have some other checks to make to be sure that is bad.. I do have 28VAC at CR1, but it will not energize fully...trigger and gun are OK in SPOT mode...CR51 has checked OK...any help would be appreciated.

    Thanks
    Chet1
Working...
X
Special Offers: See the latest Miller deals and promotions.