If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
New to the forum...I have an old MillerMatic 35S that will not feed the wire. Cr1 is not fully engaging, I have checked all the full wave bridge retifiers and all appear to be OK.. I might have a bad CR52.. but have some other checks to make to be sure that is bad.. I do have 28VAC at CR1, but it will not energize fully...trigger and gun are OK in SPOT mode...CR51 has checked OK...any help would be appreciated.