Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Miller Legend gas driven Serial # KD481281 Stock # 903039 Problem?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Miller Legend gas driven Serial # KD481281 Stock # 903039 Problem?

    Miller Legend gas driven Serial # KD481281 Stock # 903039

    Fixed a few things. And it welds nice.
    But I only have 120V gen. power at the left duplex .
    And only one leg of the 240V circuit.
    Using a VOM. CB1 (Circuitbreaker #1) has 120V
    But CB2 does not have any voltage? On the input side wire #54 CR4-4?
    Any Ideas what could be wrong?

    Next Item
    I also noticed the 120V generator power output seems ok on the one side at idle RPM.
    But doubles to 240V when I switch up to high idle- weldingspeed
    Is this normal?
    Just to be clear. That’s 240V on my VOM (in the 120v duplex)@ welding RPM
Working...
X
Special Offers: See the latest Miller deals and promotions.