If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hello,I have a Millermatic Vintage mig welder. I want to be able to weld aluminum.It is not something I will do very often but just from time to time.I need to know what is my best way to go here and what all I need to set my welder up for this.I think i need a Spoolmatic 30a feeder and a wc-24 control box.That's a pretty expensive set up if I am correct.Or should I sell that welder and buy one already made for a spoolgun?
I work in a bodyshop and most of my welding is light duty.(just some fyi)
Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below. http://www.millerwelds.com/resources...php?albumid=48
You have a choice of 3 spoolguns for that machine and you just need the gun of your choice and the 10 pin module.
Millermatic® 250/Vintage All Serial Numbers Spoolmatic® 15A, Spoolmatic® 30A
Spoolmate™ 200 Series and the 10-Pin Module #043084 ...Bob