Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Aluminum welding setup for Millermatic Vintage???

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Aluminum welding setup for Millermatic Vintage???

    Hello,I have a Millermatic Vintage mig welder. I want to be able to weld aluminum.It is not something I will do very often but just from time to time.I need to know what is my best way to go here and what all I need to set my welder up for this.I think i need a Spoolmatic 30a feeder and a wc-24 control box.That's a pretty expensive set up if I am correct.Or should I sell that welder and buy one already made for a spoolgun?
    I work in a bodyshop and most of my welding is light duty.(just some fyi)

  • #2
    A machine that is already setup for aluminum, basically just has the WC-24 already inside of it.

    You'd still need the 30A spool gun. sooooo, since you already have a machine, best just to get the WC-24, and the spoolgun. Overall it'll be much cheaper to use the equipment you already have....


    • #3
      You have a choice of 3 spoolguns for that machine and you just need the gun of your choice and the 10 pin module.
      Millermatic® 250/Vintage All Serial Numbers Spoolmatic® 15A, Spoolmatic® 30A
      Spoolmate™ 200 Series and the 10-Pin Module #043084 ...Bob


      • #4
        Thanks for the info. Now i just have to search around and see if I can find a good deal on those parts.


        Special Offers: See the latest Miller deals and promotions.