If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I've been considering one of these units to plug into my cst280 and have the ability to start with hf instead of scratch. I am looking for opinions from anyone who has used one of these. I would love to get a dynasty and just use that, but that is out of my price range. My side work would support getting something like this without impacting my regular budgets. I also figured that I could use it with a trailblazer engine drive in the future.
Not too many engine drives anymore have AC to make use of the HF, as for a DC machine, I suppose.
However, HF on steel only lasts till the arc is struck. Since you have lift arc, that would make the HF seemingly useless and not too cost effective. Only if your doing multiple pieces would make the HF box usefull for faster on starts.
Well I picked up the HF box yesterday. It came with a weldcraft wp-20 torch with protective sheath and a foot pedal. I also bought a victor journeyman OA setup at same time. The victor rig is still in the original box.
I paid $550 for both, so I think that was a good deal.