Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

I just purchased an Airco--was it made by Miller?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • I just purchased an Airco--was it made by Miller?

    Just purchased an Airco
    2.5DTR-224-A

    Understand some of the Airco welders were made by Miller and wanted to see if this was one of those units.

    Hope so, anyway, LOL

    If so, is there any documentation available at Miller, like manual etc?

    Thanks in advance

  • #2
    Miller CP-250TS

    Comment


    • #3
      Originally posted by cruizer View Post
      Miller CP-250TS
      Thanks.
      Not that I don't appreciate the response.

      Wonder if the Miller rep can confirm from their database?

      They don't look like each other?
      Last edited by TPB; 02-28-2013, 10:36 AM. Reason: addition

      Comment


      • #4
        I've seen pics of two different styles of CP-250TS. Does your AIRCO look like this?



        Comment


        • #5
          Originally posted by TPB View Post
          Thanks.
          Not that I don't appreciate the response.

          Wonder if the Miller rep can confirm from their database?

          They don't look like each other?
          Well, since I'm a Miller CST service technician, looking at the tech only site under that posted code you supplied, in the miller cross reference. I assure you thats the machine it brings up. Perhaps if you also posted maybe a picture of the machine. We could help you further.

          Comment


          • #6
            Manual for the crank-on-the-right model.

            http://www.millerwelds.com/om/o249c_mil.pdf

            Comment


            • #7
              Originally posted by USMCPOP View Post
              Manual for the crank-on-the-right model.

              http://www.millerwelds.com/om/o249c_mil.pdf
              Yea, thats it.
              THANKS.

              The manual I pulled up had the crank on the left.

              Must have made 2 different ones with the same model number

              Appreciate very much, good to go!!!!!

              Comment


              • #8
                You might want to select the CP manual and enter your serial number. There are often several manual revisions. Without a number, only the most recent manual will come up.

                One trick I use is to search for welders for sale where the serial number is listed, such as at auctions. That can help you find different editions. That's what I did here.

                Comment

                Working...
                X
                Special Offers: See the latest Miller deals and promotions.