Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Millermatic has a loose wire

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Millermatic has a loose wire

    Black wire off the drive motor isnt plugged in anywhere. Ive looked all through owners manual for a clue. Schematics i have dont show. Any help would be greatly appreciated. P.S. This is my first post on this forum!

  • #2
    A millermatic what?, there are many, a serial# to pull up the correct diagram would be handy too


    • #3
      Millermatic 35. Serial number JH212708.


      • #4
        They both wind up at CR1 relay. one goes to a brake resistor (stops the drive from turning once the gun trigger is released) Normally closed portion of CR1 relay

        The other goes to the Normally open part of CR1 relay, once energised the motor turns.


        Special Offers: See the latest Miller deals and promotions.